THREE TIER PULLING CARD TUTORIAL!!

Hey! Crafters!

Today I thought of sharing a simple tutorial of Three Tier Pulling Card.......Pull on the top tab and watch the hidden layers slide out from the bottom layer.

MATERIAL REQUIRED

1) Cardstock papers

2) Pencil and scale

3) Paper Cutter

4) Decorative Papers

5) Adhesive / glue

PROCEDURE

STEP 1: Take three cardstock paper and cut them in 11.4*29 cm, 8*26 cm, and 7.6*7.6 cm respectively.

STEP 2: Take 11.4*29cm card piece and mark at 9.6cm, 19.2cm on 29cm side. Take 8*26cm card piece and mark at 8.6cm, 17.2cm on 26cm side. And score them.

STEP 3: On the right side of the cards piece, make slits by following the template.

STEP 4: Take a strip and put in the slid as shown on both the card pieces.

(Make sure to fold the strip a bit away from the slits because it needs to move, also check whether the black strip is moving freely or not) 

 STEP 5: Unfold the 2nd card piece, apply glue to the strip only and then stick card piece measuring 7.6*7.6cm.
(Align the top side of both the pieces)

Apply glue to the left side of the card piece.

Stick it over the other side.

STEP 6: Apply glue to the strip of the largest card piece and stick the earlier prepared card on to it, align the top side of both the cards.

Apply glue to the left side of the card piece. Stick it over the other side.

Take a strip and stick it on the topmost card, to make a grip for pulling.

 STEP 7: Take decorative papers cut 3 squares measuring 

STEP 8: Stick the largest decorative paper on the card.

STEP 9: Stick the rest of the decorative papers on the respective card.

 The pulling card is ready.

Hope you all liked it!

THANK YOU!